Cisco Switch 2960 Configuration Step By Step Pdf Freel
LINK >>>>> https://tlniurl.com/2sBIcn
Now that you plugged in your switch, you can test communication between the PC and your switch using the basic IP echo server. To access the configuration on the switch. In PC1 you would type ipconfig /all:
If you plug a switch into your test device such as another PC (or a router), it should automatically find its static IP address and automatically ping your main switch - unless it is configured otherwise.
If you want to enable direct-TCP on your switch, you have to press the Ctrl + Alt keys in conjunction with their respective keys. This will enable direct-TCP on your switch. You can then access the TCP/IP configuration page by entering the following commands from the command line:
If you want to pull down the documents by using a Cisco Network Scanner, you will need to enable all the checkboxes that correspond to documents; which enables you to download the complete NetFlow data log. You can do so by putting the following command in run or global configuration mode:
access-switch1# access-config shell mode global (Shows you are in Global configuration mode)access-switch1# exit (Exit Global Configuration Mode)access-switch1# show commands (Shows you configuration commands available)access-switch1# show running-config (Shows the entire configuration available) 7211a4ac4a